Sunsynk Modbus Register 152: System Mode Time5

Technical Definition

The register System Mode Time5 at address 152 is used to monitor system mode time5 on the sunsynk.

• Protocol: Modbus RTU
• Data Type: INT16
• Unit:
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read System Mode Time5 (Address: 152)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=152, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "System Mode Time5"
  address: 152
  value_type: INT16
  unit_of_measurement: ""

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[sunsynk]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: Configures the start time for system mode 5. Units are typically hours or minutes from midnight.

Troubleshooting: Zero might indicate an inactive or default mode, or a configuration error if this mode should be active.