Marstekvenus Lilygo T Poe Pro3 Modbus Register 32101: Marstek Battery Current (Average)

Technical Definition

The register Marstek Battery Current (Average) at address 32101 is used to monitor marstek battery current (average) on the Marstekvenus Lilygo T Poe Pro3.

• Protocol: Modbus RTU
• Data Type: S WORD
• Unit: A
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read Marstek Battery Current (Average) (Address: 32101)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=32101, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "Marstek Battery Current (Average)"
  address: 32101
  value_type: S_WORD
  unit_of_measurement: "A"

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[Marstekvenus Lilygo T Poe Pro3]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: Marstek Battery Current (Average). Measured in Amperes (A). Represents the average flow of electrical charge into or out of the battery.

Troubleshooting: Zero current indicates no charging or discharging. Check load, charger, and battery status. Negative values may indicate discharge.