Deye Inverter Entities Advanced Modbus Register 252: Name inverter name setting timezone3

Technical Definition

The register name inverter name setting timezone3 at address 252 is used to monitor name inverter name setting timezone3 on the Deye Inverter Entities Advanced.

• Protocol: Modbus RTU
• Data Type: INT16
• Unit:
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read name inverter_name setting timezone3 (Address: 252)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=252, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "name inverter_name setting timezone3"
  address: 252
  value_type: INT16
  unit_of_measurement: ""

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[Deye Inverter Entities Advanced]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: Configures the UTC offset for timezone 3. Value represents hours relative to UTC.

Troubleshooting: Incorrect value may cause scheduling errors. Verify correct UTC offset for the specified region.