Wowa Epever Esp32 Modbus Register 13072: Generated energy 3 year

Technical Definition

The register Generated energy 3 year at address 13072 is used to monitor generated energy 3 year on the Wowa Epever Esp32.

• Protocol: Modbus RTU
• Data Type: U DWORD R
• Unit: kWh
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read Generated energy 3 year (Address: 13072)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=13072, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "Generated energy 3 year"
  address: 13072
  value_type: U_DWORD_R
  unit_of_measurement: "kWh"

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[Wowa Epever Esp32]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: Total energy generated this year (e.g., in kWh or Wh). Cumulative generation for the current calendar year.

Troubleshooting: 0 suggests no generation this year. Investigate system uptime since year start, review potential long-term disconnections.