Upower Modbus Register 13594: PV input Current

Technical Definition

The register PV input Current at address 13594 is used to monitor pv input current on the Upower.

• Protocol: Modbus RTU
• Data Type: INT16
• Unit: A
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read PV input Current (Address: 13594)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=13594, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "PV input Current"
  address: 13594
  value_type: INT16
  unit_of_measurement: "A"

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[Upower]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: Current produced by the PV solar panels. Units are Amperes (A). Indicates the rate of charge from solar energy.

Troubleshooting: Zero means no PV current. Check PV voltage, irradiance, panel condition, and wiring integrity.