Switchingcabinet Modbus Register 24578: Inepro PRO380 Total Active Energy Tariff 1

Technical Definition

The register Inepro PRO380 Total Active Energy Tariff 1 at address 24578 is used to monitor inepro pro380 total active energy tariff 1 on the Switchingcabinet.

• Protocol: Modbus RTU
• Data Type: FP32
• Unit: kWh
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read Inepro PRO380 Total Active Energy Tariff 1 (Address: 24578)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=24578, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "Inepro PRO380 Total Active Energy Tariff 1"
  address: 24578
  value_type: FP32
  unit_of_measurement: "kWh"

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[Switchingcabinet]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: Accumulated real energy for Tariff 1. Units: Kilowatt-hours (kWh).

Troubleshooting: 0 indicates no energy registered under Tariff 1. Verify time-of-use settings and if the load is active during this tariff.