Sunsynk Modbus Register 148: System Mode Time1

Technical Definition

The register System Mode Time1 at address 148 is used to monitor system mode time1 on the sunsynk.

• Protocol: Modbus RTU
• Data Type: INT16
• Unit:
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read System Mode Time1 (Address: 148)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=148, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "System Mode Time1"
  address: 148
  value_type: INT16
  unit_of_measurement: ""

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[sunsynk]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: System operational mode for Time Slot 1. Defines active inverter behavior during specific periods.

Troubleshooting: Zero or incorrect value may indicate configuration error or system fault. Consult manual for mode definitions.