Srne Modbus Register 263: Name solar panel voltage

Technical Definition

The register name solar panel voltage at address 263 is used to monitor name solar panel voltage on the Srne.

• Protocol: Modbus RTU
• Data Type: U WORD
• Unit: V
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read name_solar_panel_voltage (Address: 263)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=263, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "name_solar_panel_voltage"
  address: 263
  value_type: U_WORD
  unit_of_measurement: "V"

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[Srne]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: Solar panel voltage (V). Open-circuit or operating voltage from the PV array.

Troubleshooting: Zero if PV disconnected, shaded, faulty panels, or wiring issue. Check array.