Srne Hf2430U60 Modbus Register 57352: Boost Charge Voltage

Technical Definition

The register Boost Charge Voltage at address 57352 is used to monitor boost charge voltage on the Srne Hf2430U60.

• Protocol: Modbus RTU
• Data Type: INT16
• Unit: V
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read Boost Charge Voltage (Address: 57352)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=57352, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "Boost Charge Voltage"
  address: 57352
  value_type: INT16
  unit_of_measurement: "V"

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[Srne Hf2430U60]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: Voltage target (V) for the boost charging stage, typically higher than float. Units: Volts.

Troubleshooting: Zero could mean boost stage is inactive or not applicable. Check charging parameters and battery status.