Srne Hf2430U60 Modbus Register 57345: PV Charge Current Limit

Technical Definition

The register PV Charge Current Limit at address 57345 is used to monitor pv charge current limit on the Srne Hf2430U60.

• Protocol: Modbus RTU
• Data Type: INT16
• Unit: A
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read PV Charge Current Limit (Address: 57345)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=57345, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "PV Charge Current Limit"
  address: 57345
  value_type: INT16
  unit_of_measurement: "A"

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[Srne Hf2430U60]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: Maximum allowable charging current (A) from the PV array to the battery. Units: Amperes.

Troubleshooting: Zero implies no PV charging is occurring. A low or fixed value might indicate a limit reached or a configuration issue.