Solismini2000 Modbus Register 3041: Temp

Technical Definition

The register Temp at address 3041 is used to monitor temp on the Solismini2000.

• Protocol: Modbus RTU
• Data Type: U WORD
• Unit: C
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read Temp (Address: 3041)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=3041, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "Temp"
  address: 3041
  value_type: U_WORD
  unit_of_measurement: "C"

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[Solismini2000]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: Temperature. Units: Degrees Celsius (°C). Internal Temperature of the inverter or critical component.

Troubleshooting: High values indicate potential overheating due to poor ventilation, high ambient Temperature, or internal component failure. Ensure proper airflow.