Sdm120 2X Atom Modbus Register 0: SDM2 Voltage

Technical Definition

The register SDM2 Voltage at address 0 is used to monitor sdm2 voltage on the Sdm120 2X Atom.

• Protocol: Modbus RTU
• Data Type: FP32
• Unit: V
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read SDM2 Voltage (Address: 0)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=0, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "SDM2 Voltage"
  address: 0
  value_type: FP32
  unit_of_measurement: "V"

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[Sdm120 2X Atom]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: SDM2 Voltage (V). RMS voltage measured on the line(s) connected to SDM2.

Troubleshooting: Verify power source stability, check wiring integrity to the meter, confirm voltage range compatibility.