Renogy Modbus2 Modbus Register 259: $locationName $device2Name Controller Temperature

Technical Definition

The register $locationName $device2Name Controller Temperature at address 259 is used to monitor $locationname $device2name controller Temperature on the Renogy Modbus2.

• Protocol: Modbus RTU
• Data Type: S WORD
• Unit: °F
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read $locationName $device2Name Controller Temperature (Address: 259)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=259, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "$locationName $device2Name Controller Temperature"
  address: 259
  value_type: S_WORD
  unit_of_measurement: "°F"

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[Renogy Modbus2]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: Controller Temperature (°C). Monitors internal operating Temperature.

Troubleshooting: High temperatures can cause throttling or shutdown. Ensure proper ventilation and check for obstructions. Extreme cold may also affect performance.