Rd6018 Modbus Register 40: Energy

Technical Definition

The register Energy at address 40 is used to monitor energy on the Rd6018.

• Protocol: Modbus RTU
• Data Type: U DWORD
• Unit: Wh
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read Energy (Address: 40)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=40, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "Energy"
  address: 40
  value_type: U_DWORD
  unit_of_measurement: "Wh"

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[Rd6018]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: Total energy consumed or produced in Watt-hours (Wh) or Kilowatt-hours (kWh). A cumulative meter reading.

Troubleshooting: Ensure device is powered and operating. Verify load is connected and drawing/supplying power. Sensor or calculation error possible if consistently zero.