Rctpower Inverter Modbus Register 40062: Power Reduction (Power Control)

Technical Definition

The register Power Reduction (Power Control) at address 40062 is used to monitor power reduction (power control) on the Rctpower Inverter.

• Protocol: Modbus RTU
• Data Type: U WORD
• Unit: %
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read Power Reduction (Power Control) (Address: 40062)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=40062, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "Power Reduction (Power Control)"
  address: 40062
  value_type: U_WORD
  unit_of_measurement: "%"

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[Rctpower Inverter]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: Percentage or value indicating power reduction due to grid constraints or control commands, typically in % or kW.

Troubleshooting: Zero means full power output. Non-zero indicates curtailment. Investigate grid signals or control setpoints if unexpected.