.Quatt Sniffer Hp2 Modbus Register 2099: HP2 - Working Mode Actual

Technical Definition

The register HP2 - Working Mode Actual at address 2099 is used to monitor hp2 - working mode actual on the .Quatt Sniffer Hp2.

• Protocol: Modbus RTU
• Data Type: INT16
• Unit:
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read HP2 - Working Mode Actual (Address: 2099)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=2099, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "HP2 - Working Mode Actual"
  address: 2099
  value_type: INT16
  unit_of_measurement: ""

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[.Quatt Sniffer Hp2]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: Indicates the current operational state of the HP2 unit (e.g., Idle, Cooling, Heating). Units are typically defined by the device's operational codes.

Troubleshooting: A 0 value might indicate a system shutdown, error state, or initialization period. Check system status and error logs.