Pv Comm Epever Stats Modbus Register 13060: Consumed energy today

Technical Definition

The register Consumed energy today at address 13060 is used to monitor consumed energy today on the Pv Comm Epever Stats.

• Protocol: Modbus RTU
• Data Type: U DWORD R
• Unit: Wh
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read Consumed energy today (Address: 13060)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=13060, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "Consumed energy today"
  address: 13060
  value_type: U_DWORD_R
  unit_of_measurement: "Wh"

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[Pv Comm Epever Stats]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: Energy consumed by the load today. Units: kWh. Measures the energy drawn from the battery or PV directly.

Troubleshooting: Zero value means no load was active or power delivery failed. Check load status, wiring, and charge controller output.