Puffer 01 Modbus Register 2000: Name Puffer 1 Temperature oben

Technical Definition

The register name Puffer 1 Temperature oben at address 2000 is used to monitor name puffer 1 Temperature oben on the Puffer 01.

• Protocol: Modbus RTU
• Data Type: U WORD
• Unit: °C
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read name Puffer 1 Temperatur oben (Address: 2000)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=2000, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "name Puffer 1 Temperatur oben"
  address: 2000
  value_type: U_WORD
  unit_of_measurement: "°C"

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[Puffer 01]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: Buffer Tank 1 Top Temperature (°C or °F). Measures the water Temperature at the upper section of the buffer tank.

Troubleshooting: Low reading could mean sensor issue, low fluid level, or no heat input. Check sensor, fluid, and heating source.