.Procon.Sdm120 Modbus Register 6: SDM1 Current

Technical Definition

The register SDM1 Current at address 6 is used to monitor sdm1 current on the .Procon.Sdm120.

• Protocol: Modbus RTU
• Data Type: FP32
• Unit: A
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read SDM1 Current (Address: 6)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=6, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "SDM1 Current"
  address: 6
  value_type: FP32
  unit_of_measurement: "A"

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[.Procon.Sdm120]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: RMS current flowing through the monitored conductor, measured in Amperes (A). Indicates electrical flow rate.

Troubleshooting: Verify load connection and current draw. Check current transformer (CT) ratio and installation. Ensure sensor integrity.