.Procon.Finder Modbus Register 4108: Finder1 Voltage

Technical Definition

The register Finder1 Voltage at address 4108 is used to monitor finder1 voltage on the .Procon.Finder.

• Protocol: Modbus RTU
• Data Type: FP32
• Unit: V
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read Finder1 Voltage (Address: 4108)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=4108, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "Finder1 Voltage"
  address: 4108
  value_type: FP32
  unit_of_measurement: "V"

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[.Procon.Finder]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: Voltage supply to Finder1 in Volts (V). Represents the electrical potential available to the component.

Troubleshooting: A reading of 0 indicates no voltage supply. Low values suggest power supply issues or a faulty connection.