Pana Relais I2C Ds18B20 Modbus V2 Modbus Register 0: Name SDM2 Voltage

Technical Definition

The register name SDM2 Voltage at address 0 is used to monitor name sdm2 voltage on the Pana Relais I2C Ds18B20 Modbus V2.

• Protocol: Modbus RTU
• Data Type: FP32
• Unit: V
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read name SDM2 Voltage (Address: 0)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=0, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "name SDM2 Voltage"
  address: 0
  value_type: FP32
  unit_of_measurement: "V"

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[Pana Relais I2C Ds18B20 Modbus V2]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: Measures the electrical potential difference for the second device/circuit in Volts (V).

Troubleshooting: Zero or low voltage for SDM2 suggests power supply issue, loose connection, or device fault. Verify input voltage and wiring.