Must 6248 Exp T Can485 Modbus Register 15203: Charging state

Technical Definition

The register Charging state at address 15203 is used to monitor charging state on the Must 6248 Exp T Can485.

• Protocol: Modbus RTU
• Data Type: INT16
• Unit:
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read Charging state (Address: 15203)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=15203, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "Charging state"
  address: 15203
  value_type: INT16
  unit_of_measurement: ""

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[Must 6248 Exp T Can485]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: Current state of the battery charging process (e.g., not charging, charging, full).

Troubleshooting: Zero typically means charging is not active, potentially due to battery full or a fault.