Modbus Esp8266 Modbus Register 110: Hp T1 Leaving Water Temperature

Technical Definition

The register hp T1 Leaving Water Temperature at address 110 is used to monitor hp t1 leaving water Temperature on the Modbus Esp8266.

• Protocol: Modbus RTU
• Data Type: S WORD
• Unit: °C
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read hp_T1_Leaving_Water_Temperature (Address: 110)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=110, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "hp_T1_Leaving_Water_Temperature"
  address: 110
  value_type: S_WORD
  unit_of_measurement: "°C"

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[Modbus Esp8266]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: Leaving water Temperature (T1). Units typically in °C or °F. Refers to the Temperature of the water leaving a specific circuit or component.

Troubleshooting: May signal heat transfer problems, sensor error, or incorrect control settings. Validate against expected thermal performance.