Marstekvenus Lilygo T Poe Pro3 Modbus Register 35112: Marstek Battery Discharge Current Limit

Technical Definition

The register Marstek Battery Discharge Current Limit at address 35112 is used to monitor marstek battery discharge current limit on the Marstekvenus Lilygo T Poe Pro3.

• Protocol: Modbus RTU
• Data Type: S WORD
• Unit: A
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read Marstek Battery Discharge Current Limit (Address: 35112)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=35112, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "Marstek Battery Discharge Current Limit"
  address: 35112
  value_type: S_WORD
  unit_of_measurement: "A"

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[Marstekvenus Lilygo T Poe Pro3]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: Sets the maximum current the battery can safely discharge. Units: Amperes (A).

Troubleshooting: A value of 0 indicates a safety cutoff or configuration error. Ensure it's set according to battery limits.