Marstekvenus Lilygo T Poe Pro3 Modbus Register 32102: Marstek Battery Power

Technical Definition

The register Marstek Battery Power at address 32102 is used to monitor marstek battery power on the Marstekvenus Lilygo T Poe Pro3.

• Protocol: Modbus RTU
• Data Type: S DWORD
• Unit: W
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read Marstek Battery Power (Address: 32102)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=32102, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "Marstek Battery Power"
  address: 32102
  value_type: S_DWORD
  unit_of_measurement: "W"

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[Marstekvenus Lilygo T Poe Pro3]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: Marstek Battery Power. Measured in Watts (W). Represents the rate at which electrical energy is transferred to or from the battery.

Troubleshooting: Zero power indicates no charge/discharge. Check connected loads, charger operation, and battery charge/discharge state.