Marstek%20Lilygo%20Esphome%20Config Modbus Register 37008: Min. Zellenspannung

Technical Definition

The register Min. Zellenspannung at address 37008 is used to monitor min. zellenspannung on the Marstek%20Lilygo%20Esphome%20Config.

• Protocol: Modbus RTU
• Data Type: U WORD
• Unit: V
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read Min. Zellenspannung (Address: 37008)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=37008, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "Min. Zellenspannung"
  address: 37008
  value_type: U_WORD
  unit_of_measurement: "V"

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[Marstek%20Lilygo%20Esphome%20Config]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: Minimum cell voltage (V). Lowest voltage measured across any single cell. Critical for preventing over-discharge damage.

Troubleshooting: Low values suggest cell imbalance or deep discharge. Zero might indicate a faulty cell or a communication issue.