Kincony M30 Custom Modbus Register 331: m30 L3 energy sum

Technical Definition

The register m30 L3 energy sum at address 331 is used to monitor m30 l3 energy sum on the Kincony M30 Custom.

• Protocol: Modbus RTU
• Data Type: U WORD
• Unit: kWh
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read m30_L3_energy_sum (Address: 331)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=331, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "m30_L3_energy_sum"
  address: 331
  value_type: U_WORD
  unit_of_measurement: "kWh"

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[Kincony M30 Custom]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: Sum of L3 energy consumption registers. Provides a total energy usage for phase L3. Units likely kWh or MWh.

Troubleshooting: Verify individual energy registers are functioning. Check for calculation errors or data integrity issues.