Kincony M30 Custom Modbus Register 330: m30 L3 energy 10

Technical Definition

The register m30 L3 energy 10 at address 330 is used to monitor m30 l3 energy 10 on the Kincony M30 Custom.

• Protocol: Modbus RTU
• Data Type: U WORD
• Unit: kWh
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read m30_L3_energy_10 (Address: 330)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=330, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "m30_L3_energy_10"
  address: 330
  value_type: U_WORD
  unit_of_measurement: "kWh"

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[Kincony M30 Custom]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: Cumulative energy consumption for phase L3, likely in kWh or MWh. Indicates total power used over time.

Troubleshooting: Check for power outages, instrument malfunction, or incorrect wiring. Verify energy meter settings and data acquisition.