Kincony M30 Custom Modbus Register 132: m30 L1 Frequency

Technical Definition

The register m30 L1 Frequency at address 132 is used to monitor m30 l1 frequency on the Kincony M30 Custom.

• Protocol: Modbus RTU
• Data Type: U WORD
• Unit: Hz
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read m30_L1_Frequency (Address: 132)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=132, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "m30_L1_Frequency"
  address: 132
  value_type: U_WORD
  unit_of_measurement: "Hz"

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[Kincony M30 Custom]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: Indicates the electrical frequency on Line 1 (L1) in Hertz (Hz). Essential for stable power quality.

Troubleshooting: Anomalous frequency (e.g., 0 or out of range) suggests grid instability or meter fault. Check power source.