Jsy Mk 354 Modbus Register 279: Power Factor L2

Technical Definition

The register Power Factor L2 at address 279 is used to monitor power factor l2 on the Jsy Mk 354.

• Protocol: Modbus RTU
• Data Type: U WORD
• Unit: %
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read Power Factor L2 (Address: 279)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=279, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "Power Factor L2"
  address: 279
  value_type: U_WORD
  unit_of_measurement: "%"

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[Jsy Mk 354]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: Power Factor L2 (Unitless): Ratio of real power to apparent power for phase L2. Ideal is close to 1.

Troubleshooting: Low PF indicates high reactive current. Check for inductive loads (motors) or incorrect capacitor bank operation.