Jkbms Modbus Modbus Register 4788: JKBMS total charging cycle capacity

Technical Definition

The register JKBMS total charging cycle capacity at address 4788 is used to monitor jkbms total charging cycle capacity on the Jkbms Modbus.

• Protocol: Modbus RTU
• Data Type: U DWORD
• Unit: AH
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read JKBMS total charging cycle capacity (Address: 4788)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=4788, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "JKBMS total charging cycle capacity"
  address: 4788
  value_type: U_DWORD
  unit_of_measurement: "AH"

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[Jkbms Modbus]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: Total capacity (e.g., Ah) delivered over the battery's lifetime. Units like Ampere-hours (Ah).

Troubleshooting: 0 likely means a new battery. Readings should increase over time. Discrepancies suggest charging issues or data errors.