Jk Rs485 Bms10 Modbus Register 4772: Bms10 balance current

Technical Definition

The register bms10 balance current at address 4772 is used to monitor bms10 balance current on the Jk Rs485 Bms10.

• Protocol: Modbus RTU
• Data Type: S WORD
• Unit: A
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read bms10 balance current (Address: 4772)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=4772, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "bms10 balance current"
  address: 4772
  value_type: S_WORD
  unit_of_measurement: "A"

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[Jk Rs485 Bms10]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: Represents the current flow within the battery pack for balancing purposes. Units are Amperes (A).

Troubleshooting: A value of 0 indicates no active balancing current. If batteries are unbalanced and no current flows, check BMS control logic.