Jk Baterry Modbus Modbus Register 4634: Cell 13 Voltage

Technical Definition

The register Cell 13 Voltage at address 4634 is used to monitor cell 13 voltage on the Jk Baterry Modbus.

• Protocol: Modbus RTU
• Data Type: U WORD
• Unit: mV
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read Cell 13 Voltage (Address: 4634)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=4634, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "Cell 13 Voltage"
  address: 4634
  value_type: U_WORD
  unit_of_measurement: "mV"

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[Jk Baterry Modbus]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: Individual cell voltage for lithium-ion battery pack. Units: Volts (V). Typical range 3.0-4.2V per cell.

Troubleshooting: Indicates a faulty cell, poor connection, or balancing issue. May also point to battery management system (BMS) fault.