Inverter Modbus Register 96: Friendly name Total PV Energy

Technical Definition

The register friendly name Total PV Energy at address 96 is used to monitor friendly name total pv energy on the inverter.

• Protocol: Modbus RTU
• Data Type: U DWORD R
• Unit: kWh
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read friendly_name Total PV Energy (Address: 96)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=96, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "friendly_name Total PV Energy"
  address: 96
  value_type: U_DWORD_R
  unit_of_measurement: "kWh"

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[inverter]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: Total energy generated by the PV system since the device was first commissioned or reset. Units are typically kWh or MWh.

Troubleshooting: Zero value suggests no PV generation history or a PV measurement fault. Verify PV connection and inverter settings.