Imars Mg5Ktl 2M Modbus Register 5804: Isolation Resistance

Technical Definition

The register Isolation Resistance at address 5804 is used to monitor isolation resistance on the Imars Mg5Ktl 2M.

• Protocol: Modbus RTU
• Data Type: U WORD
• Unit: kΩ
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read Isolation Resistance (Address: 5804)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=5804, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "Isolation Resistance"
  address: 5804
  value_type: U_WORD
  unit_of_measurement: "kΩ"

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[Imars Mg5Ktl 2M]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: Electrical resistance between DC circuits and ground. Units: Megaohms (MΩ). Safety parameter.

Troubleshooting: Low or zero value indicates a ground fault. Immediately investigate for insulation breakdown.