Heidelberg Wb Modbus Register 9: PCB-Temperature

Technical Definition

The register PCB-Temperature at address 9 is used to monitor pcb-Temperature on the Heidelberg Wb.

• Protocol: Modbus RTU
• Data Type: S WORD
• Unit: °C
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read PCB-Temperatur (Address: 9)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=9, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "PCB-Temperatur"
  address: 9
  value_type: S_WORD
  unit_of_measurement: "°C"

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[Heidelberg Wb]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: Temperature of the Printed Circuit Board (PCB). Units: Degrees Celsius (°C). Monitors internal electronic component Temperature.

Troubleshooting: Unusual readings (too high/low) can indicate cooling failure, component overheating, or sensor malfunction.