Han S3 Modbus Register 12: Dev Contract T1

Technical Definition

The register dev Contract T1 at address 12 is used to monitor dev contract t1 on the Han S3.

• Protocol: Modbus RTU
• Data Type: U DWORD
• Unit: kVA
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read dev Contract T1 (Address: 12)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=12, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "dev Contract T1"
  address: 12
  value_type: U_DWORD
  unit_of_measurement: "kVA"

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[Han S3]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: Temperature reading T1 (likely in Celsius or Fahrenheit). Crucial for monitoring system thermal performance and preventing overheating.

Troubleshooting: Potential issues: Sensor malfunction, loose wiring, or communication error. Verify sensor integrity and connection.