Han C6 B5 Modbus Register 39: T2 Ponta

Technical Definition

The register T2 Ponta at address 39 is used to monitor t2 ponta on the Han C6 B5.

• Protocol: Modbus RTU
• Data Type: U DWORD
• Unit: kWh
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read T2 Ponta (Address: 39)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=39, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "T2 Ponta"
  address: 39
  value_type: U_DWORD
  unit_of_measurement: "kWh"

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[Han C6 B5]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: Temperature at the tip, likely in degrees Celsius or Fahrenheit. Indicates local thermal conditions.

Troubleshooting: Possible sensor failure, loose connection, or extreme ambient Temperature affecting the reading.