Growatt Modbus Register 3041: Devicename Total forward power

Technical Definition

The register devicename Total forward power at address 3041 is used to monitor devicename total forward power on the Growatt.

• Protocol: Modbus RTU
• Data Type: U DWORD
• Unit: W
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read devicename Total forward power (Address: 3041)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=3041, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "devicename Total forward power"
  address: 3041
  value_type: U_DWORD
  unit_of_measurement: "W"

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[Growatt]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: Total power flowing from the grid to the load/inverter. Units: W.

Troubleshooting: Zero indicates no grid import. Check grid connection and inverter mode (e.g., off-grid).