Growatt Esp32 Modbus Register 1054: Device name Battery Discharge Total

Technical Definition

The register device name Battery Discharge Total at address 1054 is used to monitor device name battery discharge total on the Growatt Esp32.

• Protocol: Modbus RTU
• Data Type: U DWORD
• Unit: kWh
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read device_name Battery Discharge Total (Address: 1054)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=1054, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "device_name Battery Discharge Total"
  address: 1054
  value_type: U_DWORD
  unit_of_measurement: "kWh"

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[Growatt Esp32]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: Total energy discharged from the battery since installation. Units: Kilowatt-hours (kWh).

Troubleshooting: Not increasing: Battery not discharging, or logging error. Verify battery usage and system configuration.