Geo9 Modbus Register 202: Inlet (before heater) T2 Temperature

Technical Definition

The register Inlet (before heater) T2 Temperature at address 202 is used to monitor inlet (before heater) t2 Temperature on the Geo9.

• Protocol: Modbus RTU
• Data Type: S WORD
• Unit: °C
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read Inlet (before heater) T2 temperature (Address: 202)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=202, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "Inlet (before heater) T2 temperature"
  address: 202
  value_type: S_WORD
  unit_of_measurement: "°C"

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[Geo9]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: Inlet air Temperature before any heating element. Unit: Degrees Celsius. Baseline for heating calculations.

Troubleshooting: 0 might signal sensor malfunction, no airflow, or a system in standby. Inspect sensor and airflow path.