General Modbus Register 3081: S 3081

Technical Definition

The register s 3081 at address 3081 is used to monitor s 3081 on the General.

• Protocol: Modbus RTU
• Data Type: U WORD
• Unit: kg/h
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read s_3081 (Address: 3081)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=3081, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "s_3081"
  address: 3081
  value_type: U_WORD
  unit_of_measurement: "kg/h"

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[General]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: Instantaneous current (Phase 3) in Amperes. Measures electrical current flow.

Troubleshooting: Zero indicates no load on phase 3, CT fault, or communication error.