General Modbus Register 3061: S 3061

Technical Definition

The register s 3061 at address 3061 is used to monitor s 3061 on the General.

• Protocol: Modbus RTU
• Data Type: U WORD
• Unit: kg/h
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read s_3061 (Address: 3061)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=3061, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "s_3061"
  address: 3061
  value_type: U_WORD
  unit_of_measurement: "kg/h"

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[General]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: Register 3061: May represent a secondary control parameter or feedback value. Units depend on the controlled process (e.g., speed RPM, valve position %).

Troubleshooting: If 0: Could signal a control loop issue or specific feedback state. Examine control system logic and feedback sensor.