Garo Reader Modbus Register 14: Current Phase 2

Technical Definition

The register Current Phase 2 at address 14 is used to monitor current phase 2 on the Garo Reader.

• Protocol: Modbus RTU
• Data Type: S DWORD R
• Unit: A
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read Current Phase 2 (Address: 14)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=14, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "Current Phase 2"
  address: 14
  value_type: S_DWORD_R
  unit_of_measurement: "A"

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[Garo Reader]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: Current flowing through Phase 2 in Amperes (A). Measures the rate of electrical charge flow.

Troubleshooting: Zero may indicate no load connected, a broken conductor, or a fault within the load on Phase 2.