Garden-shed Modbus Register 12558: Human devicename Load Power

Technical Definition

The register human devicename Load Power at address 12558 is used to monitor human devicename load power on the garden-shed.

• Protocol: Modbus RTU
• Data Type: U DWORD R
• Unit: W
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read human_devicename Load Power (Address: 12558)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=12558, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "human_devicename Load Power"
  address: 12558
  value_type: U_DWORD_R
  unit_of_measurement: "W"

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[garden-shed]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: Calculated power consumed by the load. Units: Watts (W).

Troubleshooting: Zero value means the load is not drawing power, potentially due to absence or system issue.