Faultcodes Modbus Register 231: S 231

Technical Definition

The register s 231 at address 231 is used to monitor s 231 on the Faultcodes.

• Protocol: Modbus RTU
• Data Type: U WORD
• Unit:
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read s_231 (Address: 231)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=231, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "s_231"
  address: 231
  value_type: U_WORD
  unit_of_measurement: ""

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[Faultcodes]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: Specific fault code from the device. Consult device manual for code interpretation. Units are code-dependent.

Troubleshooting: Indicates a specific operational error or fault condition. Requires diagnosis based on the actual fault code value.