Esphome Huawei Modbus Register 37101: Huawei meter grid voltage

Technical Definition

The register Huawei meter grid voltage at address 37101 is used to monitor huawei meter grid voltage on the Esphome Huawei.

• Protocol: Modbus RTU
• Data Type: S DWORD
• Unit: V
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read Huawei meter grid voltage (Address: 37101)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=37101, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "Huawei meter grid voltage"
  address: 37101
  value_type: S_DWORD
  unit_of_measurement: "V"

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[Esphome Huawei]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: Voltage of the grid the inverter is connected to (V). Should be within nominal grid tolerances.

Troubleshooting: Zero or out-of-range indicates grid issue or meter fault. Check grid stability and meter connection.