Esphome Huawei Modbus Register 32018: Huawei inverter PV2 voltage

Technical Definition

The register Huawei inverter PV2 voltage at address 32018 is used to monitor huawei inverter pv2 voltage on the Esphome Huawei.

• Protocol: Modbus RTU
• Data Type: S WORD
• Unit: V
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read Huawei inverter PV2 voltage (Address: 32018)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=32018, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "Huawei inverter PV2 voltage"
  address: 32018
  value_type: S_WORD
  unit_of_measurement: "V"

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[Esphome Huawei]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: Measures the DC voltage from the second solar array (PV2) in Volts (V).

Troubleshooting: Zero voltage suggests no sun exposure, open circuit on PV2, faulty wiring, or an inverter input fault.