Esphome Deye Modbus Register 90: Device name DC temp

Technical Definition

The register device name DC temp at address 90 is used to monitor device name dc temp on the Esphome Deye.

• Protocol: Modbus RTU
• Data Type: U WORD
• Unit: º
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read device_name DC temp (Address: 90)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=90, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "device_name DC temp"
  address: 90
  value_type: U_WORD
  unit_of_measurement: "º"

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[Esphome Deye]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: DC Temperature, possibly related to DC components or wiring. Units: °C.

Troubleshooting: Abnormal readings may point to component overheating or inadequate cooling within the DC section.