Esphome%20Sdm%20Modbus Modbus Register 14: Leistung L2

Technical Definition

The register Leistung L2 at address 14 is used to monitor leistung l2 on the Esphome%20Sdm%20Modbus.

• Protocol: Modbus RTU
• Data Type: FP32
• Unit: W
• Access: Read Only

How to Read (Python pymodbus)

Use this code snippet to read this specific value via RS485:

from pymodbus.client.sync import ModbusSerialClient

client = ModbusSerialClient(method='rtu', port='/dev/ttyUSB0', baudrate=9600)
client.connect()

# Read Leistung L2 (Address: 14)
# Note: Check if your device uses 0-based or 1-based addressing
result = client.read_input_registers(address=14, count=2, unit=1)

if not result.isError():
    print(f"Raw Value: {result.registers}")
else:
    print("Error reading register")

client.close()

Integration (Home Assistant)

Paste this into your configuration.yaml:

- platform: modbus_controller
  name: "Leistung L2"
  address: 14
  value_type: FP32
  unit_of_measurement: "W"

Connection Diagram

Here is the standard RS485 wiring for this configuration:

graph TD
    PLC[Host Controller / Home Assistant]
    Device[Esphome%20Sdm%20Modbus]

    PLC -- "A+ (D+)" --> Device
    PLC -- "B- (D-)" --> Device
    PLC -- GND --> Device

💡 Engineer's Insight

Analysis: Active power for phase L2, measured in Watts (W). Represents energy consumption or generation.

Troubleshooting: Zero if no load connected to L2, phase issue, or sensor malfunction.